How should my signal chain be setup? This is how it is now, Mic (Using a XLR cable)---->Presonus Bluetube (Using a TRS Cable)----->Presonus Bluemax(Using a funk cable, that goes from 2 1/4" to RCA's (Not sure if that is TRS or not) and then from RCA's I use a adapter from RCA to 1/8" to plug into my SantaCruz Turtle Beach. The reason I am asking is because I am having a noise issue (I have a thread below, this is Nutdotnet).
How should I run Signal Chain?
- Thread starter Tussin
- Start date
sonusman
Banned
Two possibilities here:
Your card may be working on the -10 operating level, and the other components working at +4. Check the documentation of the Prosonus gear to see what operating level is outputs.
Also, you may have a ground loop problem. This usually happens when you have two pieces of gear hooked up together on two different AC circuits. Make sure both units, and the computer are sharing the same AC circuit.
Good luck.
Ed
Your card may be working on the -10 operating level, and the other components working at +4. Check the documentation of the Prosonus gear to see what operating level is outputs.
Also, you may have a ground loop problem. This usually happens when you have two pieces of gear hooked up together on two different AC circuits. Make sure both units, and the computer are sharing the same AC circuit.
Good luck.
Ed