How do I fix this

  • Thread starter Thread starter bigwillz24
  • Start date Start date
bigwillz24

bigwillz24

Well-known member
This is an image of the room when i shot pink noise into it and recorded the the sound through an omnidirectional shure microphone at my sitting postion. Note the dip at 70Hz-150Hz. How do i go about fixing this.
 
Sorry I can't help directly, but try posting it in the studio building forum. There's a few acoustics whiz's who hang out there regularly.
 
without knowing the frequency response of the mic used it would be hard to say...a better view of this for you would be to use a measuring mic that is absolutely flat from below 20hz up to 40k.
 
Will,

> i shot pink noise into it <

I don't know how good Harbal is as a room analyzer, but it's not meant for that so my guess is not so good. Either way, you should take that response with a grain of salt. In all likelihood your low end response is much worse than shown, and your high end response is probably a little better.

> How do i go about fixing this. <

The solution for a skewed low end response - which is absolutely typical of all small rooms - is acoustic treatment and especially bass traps.

--Ethan
 
Thanks for the info:
But i don't think the apartment complex will take kindly to me putting up acoustic foam everywhere on the walls.

(little light bulb goes off)

Will i get the same results if i just bought some accoustic foam and hung it with a tack of something instead of spraying glue on the walls that way when its time to leave I can take it down without screwing up the walls?
 
Will,

> i don't think the apartment complex will take kindly to me putting up acoustic foam everywhere on the walls. <

That wasn't exactly what I meant when I suggested bass traps.

> Will i get the same results if i just bought some accoustic foam and hung it with a tack <

Have a look at the Acoustics FAQ, second in the list on my Articles page:

www.ethanwiner.com/articles.html

It's a long article, but when you're done you'll know a lot about acoustics and the best ways to treat these problems.

--Ethan
 
In my experience with acoustic foam, it makes no difference whether you use glue or T-pins from a fabric store to mount them to the wall. Foam panels can certainly help out with flutter echoes and high/mid absorption. However, once you research Ethan's site you will understand that you will still have a bass problem.
Good luck.

Terry
 
Thanks for the replyies guys looks like i got some reading to do :)
 
Thanks for the replies guys looks like i got some reading to do :)
 
Back
Top