garbled audio

  • Thread starter Thread starter maryslittlesecret
  • Start date Start date
M

maryslittlesecret

New member
I've had some success with CW in the past, but am still pretty new to it for the most part. Last night when I tried to record and playback audio, it was like my whole system bogged down: the midi tracks (which were otherwise playing and recording smoothly) slowed and stumbled and the audio was a slow garbled mess that was barely recognizable. Even when I opened a new project and recorded one audio track by itself, it did the same thing(?)

I have a new computer and, after scouring the CW help files, I found that my soundcard is sharing an IRQ with 2 other devices. Could this be the answer or does the problem sound familiar enough to anyone that you could tell me what else I may be doing wrong? HELP!?! Thanks.
 
IRQ 2 is a rather strange IRQ for a sound card to be occupying. IRQ 5 is your best choice if it is available. If the device is plug/n/play you should trying going into ControlPanel/System/Device manager, check properties on the card, go to Resources, and remove "Use automatic setting". Change the IRQ numbber, click OK etc and reboot. Then try again.
 
had the same problem only one time goto option audio hit wave profiler that should solve the problem i hope.
 
SAME PROB.

I HAD THE SAME PROBLEM WHEN I HAD A CRAP K62 PROCESSOR I TRIED EVERYTHING FINALLY I BOUGHT A P3 INTEL NOT HAD A PROB YET (TRY CAKEWALK SUPPORT) GOOD LUCK
 
You must log in or register to reply here.
Back
Top