M
MichaelF
New member
Hey all, just bought the Delta66/Omni bundle. Installed the sound card and the Omni, no problem. I'm following the Delta tutorial for a simple recording setup. Hooked up a mic to the Mic In (channel 1). Opened the control panel and followed the directions for setting the correct ins/outs so I could record and monitor the playback.
When I test the mic, I see the signal light on the Omni flash, but I'm NOT seeing any level on the peak meter for HW 1/2 (Delta Control Panel). I've made sure that fader is not muted and the levels are all the way up (0db). Shouldn't I see some kind of level? Anybody else run into this? It's my first go at recording and I haven't found any other posts that refer to this yet.
thanks,
Michael
When I test the mic, I see the signal light on the Omni flash, but I'm NOT seeing any level on the peak meter for HW 1/2 (Delta Control Panel). I've made sure that fader is not muted and the levels are all the way up (0db). Shouldn't I see some kind of level? Anybody else run into this? It's my first go at recording and I haven't found any other posts that refer to this yet.
thanks,
Michael