delta 44 and mixer setup

  • Thread starter Thread starter guitar9
  • Start date Start date
G

guitar9

New member
I'm using a soundcraft series 2 board 16/8/4/2 and the delta 44.Can some one help me with the best set up. Should i use the line outputs on the board to feed my card or should I send the signals to busses first.I'm only concerned with recording 4 mono signals at a time for now.My software is cakewalk 9.
 
Take the signel from either the inserts or the directouts if the board has them. Check the manual for which would be the best. You want the output thats closest to the preamp to get the cleanest signel.

On my cheep crappy Behringer mixer the only way to use a useable signel is taking it directly from the insert. I usually use a standard 1/4 cable plugged in just short of all the way. I have to playwith it a bit to get it in the right spot so that the signel goes to both the delta 44 and the mixer channel for montioring.
 
Back
Top