Delta 1010LT Problem

  • Thread starter Thread starter Elton Bear
  • Start date Start date
E

Elton Bear

Unregistered Abuser
Using Cubase SX, I've installed Cubase SX but it will only recognise input & outputs 1&2, but I want to use all 8 ins and outs on my soundcard - any ideas what I've done wrong?
 
Elton Bear said:
Using Cubase SX, I've installed Cubase SX but it will only recognise input & outputs 1&2, but I want to use all 8 ins and outs on my soundcard - any ideas what I've done wrong?
Click to expand...
You didn't read the manual. ;)

Look under the menus for VST Connections. Then add what you want to use.
 
Sorry, I didn't explain myself properly. The problem I have is within the VST connections window, I add a mono bus but there's only two inputs and two outputs to chose from, there should be eight :confused:
 
Make sure that you have the ASIO drivers selected within the "Device Setup" window. I'll check my home setup later tonight if that doesn't work.

I've used the 1010 without problems for years.
 
I think JoeNovice has your answer. You won't find all the inputs/outputs in vst connections if the ASIO driver isn't selected as your audio device.
 
You must log in or register to reply here.
Back
Top