ido1957
9K Gold Member
I think Sonar X3 has a fundamental design flaw. Well probably lots but this one came up lately....
In the channel strip, you can put a compressor after the input gain, but you cannot put one after automation.
Ok I know automation is fader related which is the last step on the channel. But (without routing to a bus) I would like to be able to insert a compressor after the automation to tame a few peaks that automation isn't precise enough to catch.
Once I've automated the fader, it's pretty much stuck where it is. Sure I can lower or raise the gain but I can't compress.
In the channel strip, you can put a compressor after the input gain, but you cannot put one after automation.
Ok I know automation is fader related which is the last step on the channel. But (without routing to a bus) I would like to be able to insert a compressor after the automation to tame a few peaks that automation isn't precise enough to catch.
Once I've automated the fader, it's pretty much stuck where it is. Sure I can lower or raise the gain but I can't compress.