Calling 828 MKII users.

[pdlstl]

I use SONAR Producer 3.

I installed my new 828 MKII tonight (software then hardware) and seems to be performing just fine except...

When I run Wave Profiler, it tells me that only 44.1 and 48 sampling rates are "okay". All other sample rates are listed as "not available".

I went into the software for the MOTU and selected a rate of 96 Khz. Ran Profiler again and it showed only 96 and 88.2 as "okay".

But when I re-open SONAR it gives me a message saying the chosen sample rate is not supported by the drivers.

What gives?

 

[Strryder]

I think the MOTU's have to be manually reset for the higher sample rates, just as you did, then you ran the wave profiler, then opened Sonar and got an error message, I'm assuming your default Sonar settings were still for the lower sampling rates, did you then try resetting Sonar for the higher SR then closing/re-opening Sonar? that might do the trick.

 

[pdlstl]

...did you then try resetting Sonar for the higher SR then closing/re-opening Sonar? that might do the trick.

No, I didn't. Will try that as soon as I get this pot of coffee down.

Thanks and will let you know.

 

[pdlstl]

Found a great thread regarding the 828 MKII as related to SONAR.

Check it out here: Click Me