S
stainlessbrown
New member
I need to connect wordclock via BNC, non terminated (10 kOhm) terminal on my RME FF800 to my ART DPSII
the RME manual leaves a bit to be desired when it comes to details... I recall "terminators" on older gear that used BNC cables... do I need one of these to connect the 2 units together? (I'm using the ART SPDIF out and in order to get the RME tyo synch up as the master clock, I need to connect it also to the RME
I'm also using an ADAT (D8) in case that's important... but the RME 'sees' it, but will not synch up without the connection of the wordclock out to the ART (or so the RME site says... but I've not gotten clarification on the BNC
Thanks
the RME manual leaves a bit to be desired when it comes to details... I recall "terminators" on older gear that used BNC cables... do I need one of these to connect the 2 units together? (I'm using the ART SPDIF out and in order to get the RME tyo synch up as the master clock, I need to connect it also to the RME
I'm also using an ADAT (D8) in case that's important... but the RME 'sees' it, but will not synch up without the connection of the wordclock out to the ART (or so the RME site says... but I've not gotten clarification on the BNC
Thanks