Behringer MICROMON MA400

[zradioman]

Would I be compromising my mic signal by using one of these?

Mic-(Behringer amp) Mic through- preamp- comp- PC?

http://www.musiciansfriend.com/product/Behringer-Micromon-MA400-Headphone-Amplifier?sku=187201

 

[Nakatira]

Would I be compromising my mic signal by using one of these?

Mic-(Behringer amp) Mic through- preamp- comp- PC?

http://www.musiciansfriend.com/product/Behringer-Micromon-MA400-Headphone-Amplifier?sku=187201

I`m not quite sure what youre asking, but this is a headphone-amplifier.
as far as I can see.

Meant to distibute sound to several headphones


As far using Behringer stuff, it could either way quality wise.

Its never been great for me, but it has done the job on a few occasions

 

[Big Kenny]

i'M WAITING FOR THE aPRIL FOOL'S THING.....

 

[Nakatira]

i'M WAITING FOR THE aPRIL FOOL'S THING.....

Well I might have gone for it, but it would be wee bit late, as its now 02. of april over here

 

[crazydoc]

I think what he's asking is "would the mic signal from the mic throughput be compromised?"

My answer would be - if the mic throughput is a passive connector that just passes the signal through, and the pickoff for the active (headphone) circuit has a relatively high impedance (2k per the specs), then the signal out to the preamp shouldn't be significantly altered.

If it suits your needs, then $20 shouldn't be too much to give it a try. You'll need 2 XLR cables - one from the mic to the unit, the other from the unit to your preamp or mixer.

 

[zradioman]

Thanks

I think what he's asking is "would the mic signal from the mic throughput be compromised?"

My answer would be - if the mic throughput is a passive connector that just passes the signal through, and the pickoff for the active (headphone) circuit has a relatively high impedance (2k per the specs), then the signal out to the preamp shouldn't be significantly altered.

If it suits your needs, then $20 shouldn't be too much to give it a try. You'll need 2 XLR cables - one from the mic to the unit, the other from the unit to your preamp or mixer.

I could always do it the right way too. . .but my sound booth is a distance away from my PC. . .so to run 1/4 cables all the way back to my sound booth (cables from guitar center)it would run me about $250 in cables.
+rep for being a mind reader- thanks dude