ADAT output calibration

A

ADATlove

New member
I'm running a pair of ADAT blackface machines (4.03 software) and I just noticed a couple of the channels are outputting at slightly lower levels than the rest. I'm going out of the +4 elco connector. I was hoping I could popit open and tune the outputs but that doesn't appear in the manual and I'd love to avoid ruining my already tempermental machines. Any ideas?
 
ADATlove said:
Anybody know what I'm talking about?
Click to expand...

Vaguely.

How did you determine that certain tracks are outputting at a lower volume?

Could it be that the track was recorded like that?
 
Take a look at the elco connector. Are any of the pins out of place. If you are using the type which terminates to A balanced TRS you may be getting only the ANTI and not the phase signal accross this cable or vice versa.
 
Thanks for the replies. I recorded an identical signal to all 8 tracks and got a lower signal back to my board on a couple of the channels. I'll take a look at the elco this weekend for sure. I might actually be switching to the unbalanced outs because I just got an unbalanced mixer.
 
You must log in or register to reply here.
Back
Top