homestudioguy
Well-known member
Well, Mr DIY is at it again. 
I designed and built some OC-703 acoustic panel wall mounts for less than $10 each using (oak-faced) 1/2 inch plywood, a 2"X4", some screws, 2 hanging brackets, 4 felt adhesive pads and 4 angle braces.
It brings the (self-covered) 2" OC-703 Acoustic Panel 4-1/2 inches away from the wall with a bare minimum of the panel being blocked, front or back.
It's not Rocket Science but it seems to work.
Here is link to step by step photos:
http://mysite.verizon.net/resqg90a/id31.html
I designed and built some OC-703 acoustic panel wall mounts for less than $10 each using (oak-faced) 1/2 inch plywood, a 2"X4", some screws, 2 hanging brackets, 4 felt adhesive pads and 4 angle braces.
It brings the (self-covered) 2" OC-703 Acoustic Panel 4-1/2 inches away from the wall with a bare minimum of the panel being blocked, front or back.
It's not Rocket Science but it seems to work.
Here is link to step by step photos:
http://mysite.verizon.net/resqg90a/id31.html
Last edited: