Search results

Just a head's up to say that Radiohead have recently given people the opportunity to remix their latest single, 'Nude' from In Rainbows! I just downloaded the seperate parts (guitar, bass, drums, vox, string/fx/etc. ). It's only in 5 parts i know but it still gives you a chance to practice...

Hi I want to retube my marshall head i bought second hand about 2 and a half years ago. I don't know the tube maufacturer that is in it at the moment, however i know they are EL34s. I have read about biasing and am completely confused by it. Also is there any SAFE way to make a 100watt head into...

I'm looking to use the auxilaries on my desk to give a headhone mix to the musicians. However the aux's are mono outs and the headphone amp has six stereo left and right inputs. Is there any way of either A) getting stereo to the headphone amp using the desk or B) just give a mono signal but...

I'm looking to use the auxilaries on my desk to give a headhone mix to the musicians. However the aux's are mono outs and the headphone amp has six stereo left and right inputs. Is there any way of either A) getting stereo to the headphone amp using the desk or B) just give a mono signal but...

My room is basically shaped like an A and it is a lot longer than it is wide. Roughly it would be about 30 feet x 10 feet. The drums are at one end facing down the room. From the floor to the ceiling along the sides of the room is only about 3 feet upwards until it starts moving towards a high A...

Hi I'm new here but have just built a studio and want to isolate the amps and the vocals from the drums as they are in the same room. The vocals dont have to be perfectly isolated because after a rough run through more than likely i would overdub afterwards. I want to do live recordings you see...

Hello all, i am new here but not really new to sound engineering, however i just got all my own gear and have set up a studio. The whole room is wood panelled but I want to isolate the amps and vocals as well as possible. I have alot of thick, hard, plywood sheets and i was going to cut them up...