Search results

I would also check the heads to make sure they are clean. Go over them with isopropyl alcohol and Qtips. Make sure you are using a compatible tape as well! Try a different reel of tape. This is not a DBX issue. The DBX is to lower the noise floor. Another big area- look at rear and make...

I was stunned to find that Tascam in LA has some pots in stock. Check with them. Also Google "potentiometer" and you'll come up w/incredible info. Look up also CTS electrocomponents. Forgot to include the link! http://www.ctscorp.com/components/potentiometers.htm I was very surprised to find...

We won't hold that against you. There are 32 relays at $2.76 each totaling $88.32 plus postage to you. Not a ton of $. Let me know if I can help.

Mouser and Digikey have the relays in stock!

There is usually enough units being broken down to yield parts, and then the wizards come up with ways to get around the impossible. I believe the last 8 track 1/4" was the Tascam 388. Don't expect much new until China starts flooding the maket with thier versions.

you don't want to purchase belts until you need the. They can age. what parts could you buy that you know you would need? Enjoy what you have and keep them running as best you can.

Sure no prob, Dan. I have the 3700 manual as well. It is huge however. Let me know. I will look at your site but my Swedish is bad!!! regards Greg Calo

Jeff sounds biased to this.

Jeremy Just saw your message. You need belts in that machine! I'll see what I have for manuals but need an e-mail address. regards, Greg Calo

Make sure to get the results on tape!

Contact Ole Bob at Vintage Electronics Sales, Repair, Parts for Marantz, Pioneer, Teac, Etc. I think he'd even have a belt for Abe Lincoln's pants!!! Belts get replaced and not adjusted. You may also need to remove moving surfaces, clean, and relube them.

Chances are that if you had to replace a power transformer you might want to completely rebuild your power supply. I would also look at every lead off the transformer to make sure you have them correctly placed.

The boards do have the same P/N. I was not sure if the relay number you stated is the same as what Tascam shows as the applicable part for them. But apparently you determined that which is good. If they work maybe I should buy a few!!!

MS 16 K1 relay is a 24V G2V-282P; K2 relay is 24V MR62-24S You will have to check with Hamlin Electronics for more information at Hamlin Custom Sensors, Reed switches, Reed relays, Sensor products

maybe that was not the correct transformer!

International House of Pancakes?

Have to check the book, and that will be a bit later. Sorry two projects going plus a long phone call! Talk about multi-tasking!

can't say and I am jammed at moment to be able to check. when I have done this project I'll try to check for you

Whenever possible you equipment should be on a dedicated circuit that runs directly to the breaker box. Also good to use a Panamax filtration device such as this or one of their other products. They clean up noise big time. See: M4315-PRO | A/V Components | Products | Panamax.com They use an...

try different cables and check for a ground loop. You may have to "lift the ground" on one piece. Look for a ground lift switch on one piece of that equipment