Recent content by fredphoesh

Hi, I've previously used XLR out, so this is my first time with RCA. It's definitely faulty but I've ordered some XLR to RCA cables which should work fine. Thanks for the input, Mark.

Hi spantini, thanks, but that is the first thing I tried. With volume full and my amplifier turned full, I can faintly hear the music. It doesn't work!

I am having a similar problem though for me I am using RCA out of the Behringer to RCA In on my amplifier... which should work fine, but does not! I ramp the sliders to max and turn up the amp, hear enormous amoutns of noise and VERY faint music.... this is obviously not as it should be, and...

Hello peeps, I have changed amplifiers and the new one needs RCA, not XLR, so I am trying to use the RCA output from the Behringer x1222USB but I cannot get any sound out of them. The manual (which this forum will not allow me to post a link to) does not explain how it is done, or perhaps it...

I have just discovered that Behringer stopped providing their own drivers for some reason and apparently using their drivers results in much lower noise... so see this youtube video some other chap made, there are direct links to the behringer drivers. good luck. mark search youtube for Fix to...

Hi Actually the problem exists even if I unplug the microphone... ie when I turn on the phantom power switch on the macke, the volume dips 90%... so it's not mic related! I can't find any mention of this being normal on Mackie's site... so I am assuming there IS a fault with the mixer right? tx...

Hello all. I have an old Mackie 1402 vlz3 mixer and was just plugging in a Rode Nt-1 mic. When I switched on the phantom power, the output volume of the mixer to my speakers cut about 90%. Turn the power off, volume goes up again. I was not expecting this as I want to be able to hear what I am...