ron-e-g
Member
Hello. been awhile since I've posted but...I've been around. Today I was checking the levels on the board. I engaged the on board oscillator set it to 1K And started sliding the PGM busses to set the VU meters at 0VU (nominal +4). All except buss 3 are close to the 0 mark on the fader scale. But buss 3 has to be raised to +7 VU above the others. I'm now wondering if it's the meter itself or the monitor module. As this board is all balanced (minus the direct outs). How is the best way to connect a tester to the PB-664 patchbay (TT/Bantam) to check the feed of the PGM-outs?
Also, the manual mentions adjusting the semi-fixed resistors on the VU PCB. How would this be done, if found to be necessary?
Ron
Also, the manual mentions adjusting the semi-fixed resistors on the VU PCB. How would this be done, if found to be necessary?
Ron