Hello everyone, long time reader first time poster.
I have used the search function but haven't found this problem before.
I was doing some recording with my band on the weekend, I have the M512 recording onto a Tascam 38. Everything was going great until,,,,, set everything up for a vocal overdub, hit record and there was no sound. Looked up at the board and all the overload LED's were on all 12 channels even though I was only using one mic input and four tape inputs.
Turned the desk off for about an hour, turned back on, was still lit up. Turned of again, unplugged everything, waited an hour, turned back on, still all overload LED's stay on. I also noticed that when I press the solo or PFL that light doesn,t come on.
What has happened!!!!
Aaron
I have used the search function but haven't found this problem before.
I was doing some recording with my band on the weekend, I have the M512 recording onto a Tascam 38. Everything was going great until,,,,, set everything up for a vocal overdub, hit record and there was no sound. Looked up at the board and all the overload LED's were on all 12 channels even though I was only using one mic input and four tape inputs.
Turned the desk off for about an hour, turned back on, was still lit up. Turned of again, unplugged everything, waited an hour, turned back on, still all overload LED's stay on. I also noticed that when I press the solo or PFL that light doesn,t come on.
What has happened!!!!
Aaron