Search results

  1. 1

    Saturn Diffuser

    http://www.soundcontrolroom.com/products/diffusion/saturn.htm hmmm. seems too small?
  2. 1

    How to determine mode vs SBIR issue?

    I have a null at 70 & 120hz present at the mix position. The fundamental mode is @ 45-ish hz depicted as attached, but I'm getting a deep null a higher range and its harmonic. I have preliminary treatment up, however the rear wall is not compete, as I am confused as to the approach to take at...
  3. 1

    Damping a wall heater

    Any ideas how to damp a ambient wall heater made of Sheet metal ? It rings @ +5khz MLV type rubber or composite do it? http://www.soundprooffoam.com/vinyl-barrier.html T
  4. 1

    Passive attenuators(volume control) & HP anomily-for monitors??

    I read that a passive attenuator (volume controller) can create a HP filter due to high capaciitor rating in monitor(powered speaker) cables impedance rating. An other words a decent passive attenuator can cause loss of HF due to mis -match of impedance of the controller and...
  5. 1

    Soundclick charts

    What do folks here think of Soundclick tune charts? I tend to use SC as a tune dipository for sharing etc. When I check out folks material, the charts are static on the top end even if they suck? Anyone know how they are charted, by popularity or hits? I ask this because I fnally broke the #1...
  6. 1

    monitor port design -Harvey?

    Harvey or anyone? How does the design of a monitors port design effect the "sound". As an example: 1. Dynaudio Bm5A has rear port design with a rectangluar opening at the of the cabinet. 2. Adams A7 has a port in front with a round opening. I realise its design is to match the complete...
  7. 1

    check 1..2..

    Hey hey hey, been a while Pls check out new tunage .. actually its a demo for a flautist friend http://www.soundclick.com/bands/default.cfm?bandID=205899 Tune: Handedprints:D Thanks for T
  8. 1

    Stretched ribbon?M160

    What happens when a ribbon (mic) is stretched? Does it lose low end? Blowing into a ribbon is a no-no. My Beyer M160 was blown into at a session last night, but seems to be OK. the bastid :eek:
  9. 1

    RME ADi-2/ULN-2 or??

    Is the ADI-2 all that? At that price, maybe I should go for the ULN-2? Using MAC w/ DP/1224/2408mkii-324 PCI I think its time to upgrade the ol' convertors. Room is treated, front end is decent- ADesigns P-1 (x2), Grace 101, Soundcraft SX for other duties. Mics 414, Sm81x2, GT44, M160, M201...
  10. 1

    Little Sun

    Hey dudes and dudettes (are there any here?) LOL :D I'll be leaving the country for a week and few days. So I thought I'd leave with something for ya'll to critique. http://www.soundclick.com/clavetone Tune is Little Sun. 1st stab at recording soprano sax. Yeah yea its not rock like most...
  11. 1

    A Designs P-1

    Anyone know of a good place to get the pre? My normal shop is out. Front End Audio -seems to carry, but have not shopped there before. Hey isn't that War's place? Happy shopping there? Thanks
  12. 1

    Need a drummer on a demo

    calling all drummers!! I need some help here for a drum kit. Mainly to assist in getting a demo done for a local flautist. You can check out a my recent post here.: http://www.homerecording.com/bbs/showthread.php?t=225483 Remember its a demo. The new tune is a fake book classic, however the...
Back
Top