Recording On A Budget/compressor?

  • Thread starter Thread starter ripingitar
  • Start date Start date
R

ripingitar

New member
I Am Currently Recording Through My Yamaha Mg16-4 Mixer And
A Delta 1010lt ...and Of Course Some Various Akg Shure And Oktava Mics.......i Am On A Budget And Need The Most Bang For My Buck...
I Am Debating On What My Next Peice Of Gear Should Be??? I Was Thinking Of Acquiring A Compressor For Input Channels???
How Much Will A Compressor/limiter Improve My Sound Other Than Stopping Peaks... In Comparison To Compressing After The Track Is Recorded With Plug Ins ???
 
Invest in an RNC FMR compressor. They run for under $200.00. They are THE best compressors in the world for that price range. It's one of those long term investments you will like. Here is the link to the product:

http://www.fmraudio.com/RNC1773.HTM
 
Typing With The First Letter Of Every Word Capitalized Is Annoying To Read...
 
amra said:
Typing With The First Letter Of Every Word Capitalized Is Annoying To Read...
Click to expand...

did'nt even notice until someone screamed it out. :rolleyes:
 
I noticed it right away! I guess I'm used to reviewing engineering documents at work with less than stellar grammar, and things jump out at me very easily.

I Two Find It Very Annoying And Distracting. What Do U Think? :D

TravisinFlorida said:
did'nt even notice until someone screamed it out. :rolleyes:
Click to expand...

Typing With The First Letter Of Every Word Capitalized Is Annoying To Read...
Click to expand...
 
What instruments are you recording? I find that I prefer to run things in without compression... unless it's a percussion instrument. If you run at 24bit then the noise floor is low enough that you don't need to run the inputs too near 0db anyway.
 
If you really need a compressor, there is no way around RNC for the best bang for the buck in the cheaper end.. but do you really needc a comp..? I solely use software compressors like blockfish etc. and apply the compression after the track is recorded, when mixing.

If your only pre's are those in the yamaha mixer, maybe you should consider investing in a better preamp..?

just my opinion..
 
Haveing a hardware comp to compress on the way in is nice sometimes, but I get the feeling your money could be better spent elsewhere. What's your complete signal path, what's your monitoring setup?
 
signal path is mics ....mixer ...soundcard......i have crappy monitors....
 
EVERY source on this board it seems would point to the FMR RNC! I have found that any largely unanimous opinion on this board has always been very reliable!
 
metalhead28 said:
EVERY source on this board it seems would point to the FMR RNC! I have found that any largely unanimous opinion on this board has always been very reliable!
Click to expand...

I have found the complete opposite. Because people working on a "home recording" budget don't get to try many things, so there opinion is based on their limited experience with the few pieces of gear they own.
 
ripingitar said:
I Am Debating On What My Next Peice Of Gear Should Be??? I Was Thinking Of Acquiring A Compressor For Input Channels??
Click to expand...
What are you doing for monitoring at the moment? (that includes acoustic treatment).
 
BRIEFCASEMANX said:
I have found the complete opposite. Because people working on a "home recording" budget don't get to try many things, so there opinion is based on their limited experience with the few pieces of gear they own.
Click to expand...

I think that is true for a lot of boards, but this board seems to have a large %posters that actually do this for a living. If anything I would say this board is maybe a bit slanted towards professional recording rather than home recording.
 
You must log in or register to reply here.
Back
Top