Recording aborted

[bre]

Hi!
I have 2 problems:

1.
When I try to record an audio file I recive this message: "Audio recording aborted.The disk is full".

I therefore saved the project in question on an other USB stick.
But when I open the project from this new USB (4 gig) and try to make the recording I still get the same message. (I Checked the new USB and it has almost all the 4 gigs still free).
Why do I still get this message? and what can I do?

2.
When opening a project from the new USB I get the message that some files are missing.
I saved the projects in question by "Save as" and selected the new USB.
Does not all the audio files involved in the projects move to the new place together with the project?

regards B

 

[wim van p]

The message the disk is full comes most of the time when your indicators above the event display are in the wrong position, resulting in a file which is so long that the size becomes to big.

If you save a file, or use save as, you only save a small .cpr file which contains the instructions where to get the files required to load your project.

This files does not contain any audio etc.

If you want to store the whole project you must use the Back up project command.

Cheers

Wim

 

[legionserial]

This files does not contain any audio etc.

If you want to store the whole project you must use the Back up project command.

I'll bet this is the problem right here.

You've saved the cpr file to the USB stick, but have you changed where your audio files are recorded to?

What you need to do is get the entire folder for that project from your hard drive, and move it all to the USB stick.

 

[bre]

Thanks for the answers!

I have move all the files to separate folders.
B