Please help a newbie connect his recording equipments

  • Thread starter Thread starter tduy87
  • Start date Start date
T

tduy87

New member
Hello all,

I have acquired : Art tube preamp
M-Audio 1010lt
Behringer mixer
KRK Rokit 5 monitors
Rode NT1-A Microphone

Everything is connected fine but I have problem with playback from the mixer. For recording, mic>preamp>mixer line input. From mixer, sub 1-2 output to rca input of 1010lt audio interface. I get clean and nice signals. For playback, 1010lt output to 2-Track/USB RCA input. I get no signal going to mixer and playback from monitors. Anyone know why? Thank you in advance for your help!
 
I might be mildly confused here, but why is the mixer even in your input chain? I suppose I could see using it as a "volume knob" for your monitors, but ---- what's it there for?
 
tduy87 said:
How do you suppose I connect it?
Click to expand...

You might want to say what the mixer is....

You say your interface is sending to the mixer, but have you told your DAW to send there? Sorry, I am at a loss as well, as to why the mixer is a part of your configuration.

More details, and maybe I can understand.

Willing to help here. :)
 
After fiddling around, I think I have it figured out. I went from mic>preamp>1010lt input. 1010lt output>mixer input>monitors. Everything seems to be working I think :) . I have a behringer x1622usb mixer.
 
tduy87 said:
After fiddling around, I think I have it figured out. I went from mic>preamp>1010lt input. 1010lt output>mixer input>monitors. Everything seems to be working I think :) . I have a behringer x1622usb mixer.
Click to expand...

That sounds right, but I am not sure why you have the mixer in the setup. The Delta has two preamps right? And audio outputs?

I am not a guru of any sort, when it comes to this interface you are using. I just have experience, with not liking anything from Behringer Xenyx line. Not as a recording input chain anyway. I am not a Behri-basher, just know that is not good for a preamp input chain. :)
 
I use the mixer to control volume of my studio monitors for mixing and for headphones.
 
That's probably what I'd do if that's the rig I was working with.
 
You must log in or register to reply here.
Back
Top