One Channel output?

  • Thread starter Thread starter CuntreeBoi
  • Start date Start date
C

CuntreeBoi

New member
First of all my setup....i am running my keyboards and mics through a mackie VLZ board and i am running that to a SBL Value card. I was trying to dump some tracks off my Keyboard, to Sound Forge(new user of SF) and I could only get signal through the right channel? Where is my problem? I went and tried to run it through the creative labs that comes with SBLV and i only picked up one signal again! Could someone help me out of this rut!!!!!

Thanks
 
- make sure that you're using the 'line in', not the 'mic in'
- I'm assuming that you're running stereo line outs of the mixer to a stereo 'Y' cable with a single 1/8" stereo jack? if not that's what you need
 
You must log in or register to reply here.
Back
Top