New Setup.. Not working.. Help

  • Thread starter Thread starter iproduce
  • Start date Start date
I

iproduce

New member
Ok, I unplugged all equipment then replugged it in..

This is my setup..


Microphone - Mic Input
Headphones - Phone Input

Dual 1/4 to RCA - Into "Main"-1/4 and "Studio Monitors"-Rca
Dual RCA to RCA - Into "2T RTN" and "Soundcard"

RCA to Conversion cord - Into "REC" and "Studio Monitors"

Heres a dialog I made
http://www.blaakmedia.com/dialog.jpg

Problem
It won't record, Im getting sound into my headphones and speakers but It wont record.

Hope that sounds clear thanks please help..
 
What software are you using to record with?
I would bet it's the options in the software..like the inputs aren't enabled or in the control panel the inputs aren't selected.
 
Uh, that's a diagram, not a dialog.

From the diagram, it looks like you only have the line out (or is it the line in?) of the sound card connected to anything.

You also have only one side of the Main outs going to the speaker line in. and the other wire (from the mixer's tape outs) going to that other Line In connector that I can't quite read...
 
go to your Cakewalk forum thread... I answered it there. This one is cross-posted in too many forums.
 
You must log in or register to reply here.
Back
Top