Need some help finishing the deal - making mixes (setup)

  • Thread starter Thread starter mup1537
  • Start date Start date
M

mup1537

New member
So I want to start mixing some thing together like dj's do and I am deciding how I want to go about setting it up... I have a lexicon lambda card :

these are the features:
• 5 analog audio inputs
• 2 - XLR mic inputs with extremely low noise dbx®
preamps, 44 dB gain,
and +48V phantom power (switchable)
• ¼" TRS Insert jack on each mic input
• 2 - ¼" analog RF filtered TRS active-balanced line inputs
• 1 - ¼" ultra-high-impedence analog instrument input
• 2 - ¼" analog TRS active line outputs
• High powered headphone amplifier
• MIDI In and Out
• 24-bit A/D and D/A converters, supporting sample rates of 44.1 kHz and 48 kHz
• Zero-latency analog record monitoring with adjustable balance between
Direct and Playback
• Stereo and Mono input source monitoring

I am trying to figure out how traktor works with this in the routing. I only seem to have an output left and output right ... How would that work for djing? Left for one deck and right for another? I don't even think this soundcard can do headphone monitoring but I am not really sure. Any ideas?

I can't even think about getting a controller until I figure this out.
 
Back
Top