iMultimix 8 usb recording problems

  • Thread starter Thread starter racka11
  • Start date Start date
R

racka11

New member
I have problems with mic output signals from iMultimix into computer.
I connected mic (shure 58A) into mixer and put all levels to 90% of maximum, but I still cant get stronger signal than -60db into computer (Mac, LogicPro). However if I connect instrument into mixer I become strong normal signal, so I have to use mic input via keyboard to record vocal. I also try with condensed mic (+48V) but the result was the same. Otherwise mixer is in a great working condition. Please give me some advice.
 
Nice looking machines.
Which do you have and which outputs are you using?
Also check for mic/line and PAD switches.
 
On mixer I am using Line1 (XLR connector) for Mic, for keyboard (KN7000) I am using Line IN L+R mono connectors, Mixer and Mac are connected via USB cable. The PAD switch is set on MIC/LINE.
 
On mixer I am using Line1 (XLR connector) for Mic, for keyboard (KN7000) I am using Line IN L+R mono connectors, Mixer and Mac are connected via USB cable. The PAD switch is set on MIC/LINE.
Click to expand...
Very nice unit!
I'd go Channel 1 XLR for mic (obviously) and Channels 5 & 6 for keyboards.
If, as you say, you have the faders (at the bottom) and gain (at the top) set to 90% and provided that none of the buttons on those channels are pressed in then you should have lots of volume.
That brings you over to the Record Levels array at the bottom right but that seems to be for Ipod use only.
You do have the power hooked up as well as the USB, right?
 
You must log in or register to reply here.
Back
Top