help needed:Kurzweil KSP-8+Samplitude+Lynx

  • Thread starter Thread starter violindave
  • Start date Start date
V

violindave

New member
Trying to go into KSP-8 for effects from Samplitude via LynxTwo ADAT and back into Samplitude.

I have signal showing up in the output mixer of the Lynx. I have signal showing up on the meter stage of the KSP-8, but nothing coming back in to Samplitude.

I've tried to figure it out with the manual and it's over my head.

I'm trying to send tracks out [between one and eight at a time] digitally from Samplitude via the Lynx/ADAT into the KSP-8. Then back into the KSP-8 and record the effected tracks as new tracks in Samplitude

I would be extremely grateful if someone understands this setup and can walk me through it in simple step by step fashion.

I think I need someone to walk me through each stage so I have it setup right at each point:
settings in Samplitude
settings in the Lynx mixer
settings in the KSP-8

I'm pretty sure I have Samplitude right but could even be wrong there.
cheers
Dave
 
Your studio configuration in the KSP8 is probably not right. Make sure you have the signal flowing to the correct outputs.
 
SonicAlbert said:
Your studio configuration in the KSP8 is probably not right. Make sure you have the signal flowing to the correct outputs.
Click to expand...


I don't know how to change the signal flow in KSP-8.

I see signal at the output meters, but none coming back to Lynx or Samp

where do I make that change. In master config there's no option I see to change it. input 1 goes to output 1.

cheers
Dave
 
If you see the signal on the KSP8 output meters, then it's outputting signal. Check your settings on your Lynx or in Samplitude. It's probably something very simple, a routing thing or channels that have to be enabled.
 
Got it fixed

1. wasn't hooked up right
2. lynx mixer and Samplitude play and record channels not set right

cheers
dave
 
You must log in or register to reply here.
Back
Top