Efx track stereo

  • Thread starter Thread starter Caspaas Spook
  • Start date Start date
C

Caspaas Spook

New member
Hey people! How is everyone doing??

I have four audio tracks using one efx track, all is good and well, BUT, how do I keep each track's stereo panning because once it is channeled through the efx track, all four tracks just play centered. I need that panning to remain at hard left, right and 70% 70%.

Please! Any help would be appreciated!

Thanks!!!:guitar:
 
Sounds like you have the tracks going through the fx? Fx should be getting a split (in the rest of the world that's called an aux send..) off each track, with the fx on its own bus (or 'sub group). The main track signals continue on their way to the main mix.
 
What mixsit said.

You want to set up a parallel effects loop, with the audio tracks routed normally to the main mix bus and a post fader aux send (whatever that may be called in Cubase) from each audio track to the effects track. The effect (probably reverb, right?) should be set to 100% "wet", with no dry (unaffected) signal passing through the effects track. Then use the output fader of the effects track to blend the effect with the unaffected dry tracks.

The big advantage is that you can control the amount of effect on each audio track by how high you set the aux sends.
 
Back
Top