Edna (Peter)

[Edna]

Hi All.

My Son has a Tascam US-428 and the Right channel of the Analogue Output (Line Out and Headphones) has gone low level.
It does not 'respond' to percussion testing (tech speak) for tapping it.
Does anybody have access to a schematic diagram, I am happy to work down to component level on surface mount boards, but I am not happy to attempt it without appropriate knowledge.

Thanks
Edna (incase u were wondering, an old school nickname)

 

[Armistice]

You may be best off approaching Tascam.... I'm going to assume you're scoured the old website for one and haven't found it - these'a a lot of documentation there but I didn't see a schematic ... in which case, unless it's in a manual, it probably doesn't actually exist for public consumption...

Perhaps try the Tascam forum, down below...

Good luck...