Delta 1010 with Sonar only has 4 ins and 4 outs

[OPunWide]

I finally got my M-Audio Delta 1010 (a 2 week struggle with MF, but they also did the price match when it finally shipped) and am trying to run it with the eval version of Sonar.

The control panel works correctly, and "Delta 1010 1/2" thru "Delta 1010 9/10" are highlighted under "Audio Options/Drivers" for both input and output in Sonar. Under "Audio Options/Driver Profiles" the card is listed as a "Delta 1010 1/2 (6 in, 5 out)", which seems odd but it's the only choice.

I can record and play back to "Delta 1010 1/2" and "Delta 1010 3/4", but selections for 5/6, 7/8 and 9/10 are missing as options for any of the audio tracks.

Any idea how to get them to show up?

BTW, installation of both Sonar and the Delta was no problem at all on a P4 running W2k, and other than the above, everthing seems to be working fine.

 

[keith turner]

try this to get your outputs to show up. under audio options general,i believe,set virtual mains to 4.open the console view and set main output a to 1-2,b to 3-4, c to5-6 and d to7-8.if you are able to do this then you should be able to route your tracks to any of those output pairs. as for your missing inputs just make sure they are enabled in your deltas control panel then check sonar audio>drivers and make sure all of them are highlighted their.maybe run wave profiler for good measure too.you can also check the aud.ini file in sonar to make sure it is listing all your inputs and outputs.good luck, keith

 

[OPunWide]

Thanks, changing virtual mains to 4 fixed everything.