Cubase 6 - template load causes loss of input connections

  • Thread starter Thread starter hazeyjane
  • Start date Start date
H

hazeyjane

New member
I purchased Cubase 6 recently. When I load a song created in version 4 (my previous version) all is well. However when I try to create a NEW song using any of the supplied templates, I can no longer see any input coming through from my mic or guitar.

MIDI signals are ok. If I switch back to an existing song, they reappear. I can't see in Device Setup why this might be although for the templates, the first Analog input shows active and the second one as inactive. (On exisitng songs BOTH show as active)
Can someone pleas put me out of my misery and say why this might be? It is driving me up the flippin' wall!!

Chris
 
When you create a new project you need to assign your inputs and outputs to each individual track.

You can then save those settings as a template.

You should also be able to save the settings in your existing project and open that as a new project and have your saved settings just as they are in the existing project.
 
Back
Top