P
Phil Istine
New member
Hi,
If this post looks familiar, I <a href="http://www.homerecording.com/bbs/showthread.php?t=112210">posted</a> about it a few months ago. I'm back on the case!
I'm using an M-Audio Audiophile 2496 sound card with Adobe Audition. For this test, I am plugging a diskman directly into the sound card input. If I use the Windows Sound Recorder (it records at 44100, 16 bit), it records the music fine. If I use Audition, I get occasional clicks. You can actually see where the waveforms distorts (vertical slant, instead of a curve) as if it were skipping a few samples. I've set recording to 16-bit.
I have disabled all video driver acceleration, set the screen to low resolution, deactivated the virus scan, unplugged it from the network, checked for IRQ conflicts, rebooted and closed all applications. Everything is connected to a surge-protected power bar.
The problem, I think, is a software one. It's as if the two sampling rates weren't quite meshing, though the clicks aren't regular. They just happen once in a while, every 10-60 seconds.
Where can you set the sampling rate in Audition? I see that it says 44100 on the status bar, but I can't seem to find where that is set. If I go to View/Wave Properties/Sampler in the Edit View, I see Sample Period: 1/44101. I find that extra 1 somewhat troubling, but that gets set automatically.
One thing I did notice was that Audition was changing the sample rate in my sound card's control panel to 32000 whenever I would start recording. I then locked in the 44100 rate on the sound card control panel. The rate no longer changes, but that didn't help.
I've tried many different buffer size & number setting without luck.
Any ideas would be very appreciated! Even just telling me how to change the sample rate would be great..
Thanks!
If this post looks familiar, I <a href="http://www.homerecording.com/bbs/showthread.php?t=112210">posted</a> about it a few months ago. I'm back on the case!
I'm using an M-Audio Audiophile 2496 sound card with Adobe Audition. For this test, I am plugging a diskman directly into the sound card input. If I use the Windows Sound Recorder (it records at 44100, 16 bit), it records the music fine. If I use Audition, I get occasional clicks. You can actually see where the waveforms distorts (vertical slant, instead of a curve) as if it were skipping a few samples. I've set recording to 16-bit.
I have disabled all video driver acceleration, set the screen to low resolution, deactivated the virus scan, unplugged it from the network, checked for IRQ conflicts, rebooted and closed all applications. Everything is connected to a surge-protected power bar.
The problem, I think, is a software one. It's as if the two sampling rates weren't quite meshing, though the clicks aren't regular. They just happen once in a while, every 10-60 seconds.
Where can you set the sampling rate in Audition? I see that it says 44100 on the status bar, but I can't seem to find where that is set. If I go to View/Wave Properties/Sampler in the Edit View, I see Sample Period: 1/44101. I find that extra 1 somewhat troubling, but that gets set automatically.
One thing I did notice was that Audition was changing the sample rate in my sound card's control panel to 32000 whenever I would start recording. I then locked in the 44100 rate on the sound card control panel. The rate no longer changes, but that didn't help.
I've tried many different buffer size & number setting without luck.
Any ideas would be very appreciated! Even just telling me how to change the sample rate would be great..
Thanks!