Calling all Tascam M-308, M-312, M-320 users!

  • Thread starter Thread starter sweetbeats
  • Start date Start date
sweetbeats

sweetbeats

Reel deep thoughts...
Hey, would anybody with an M-300 mixer and a full service manual be willing to post up specs on all the pots used in the M-300?
 
If you can WAIT till I get home, i can get these for you.
I presume by specs you mean the values of each type of pot. I mught actually have a PDF of the manual....I'll look
 
Still looking for the PDF, but.....

For the stacked pots like eq, I interpreted which value was which pot.
I do not know if the pan pot values are from each side of center, but that’s how interpret it.


Channel Card: Pan: 5Kohm with center click
Effect: 50 K
Aux1: 50K
Aux2: 50K
Eq Lo: 5K (gain) 200K (sweep)
Eq Mid: 5K(gain) 200K (sweep)
Eq Hi: 100K with center click
Trim: 5K mic 20K line

Buss Amp: Level: 5K
Pan: 20K with center click
Aux: 50K

Aux PCB Aux: 50K
Effect: 50K
Pan: 20K with enter click
Effect level: 10K

Monitor: Solo: 5K
Monitor: 20K
Other(cant read my scrawl from last night) 20K
 
techno, thank you for taking the time to put up those specs, and for your continued work on looking for a pdf. I appreciate it. ;)

Gotta go "spread it around" some more so I can give you some chiclets!
 
Hmmm....I seem to have been mistaken about a 3xx pdf....I have a 388 pdf, but I only have hardcopy oin the 3xx. I thought about doing the pdf conversion, but now looking at the 3xx manual it is mostly 2 and three page foldouts and would be difficult to scan and read.

Sorry sweetbeats...your gonna have to pony up for a hardcopy. I'll answer questions if you have them however....
 
Hey, no prob, techno. I really, really appreciate you checking into it. Not sure when I'll pick up the manual...kinda depends on what I end up doing with the 308B, but if I have specific questions I'll post them up in my "Tascam M-308B Story..." thread...if you don't pick up on it forawhile I might PM you if that's alright.

Thanks for the help! ;)
 
sweetbeats said:
Hey, no prob, techno. I really, really appreciate you checking into it. Not sure when I'll pick up the manual...kinda depends on what I end up doing with the 308B, but if I have specific questions I'll post them up in my "Tascam M-308B Story..." thread...if you don't pick up on it forawhile I might PM you if that's alright.

Thanks for the help! ;)
Click to expand...

ok by me. I can probably scan and send individual schematics
 
You must log in or register to reply here.
Back
Top