Bleeding in Group channel

  • Thread starter Thread starter Rusty K
  • Start date Start date
R

Rusty K

New member
Hello,

I've been experiencing a minor problem with the group function. I usually group my drums first then later if needed I group my vocals. Whenever I go to this second group channel and solo it I get some of the drums tracks bleeding in...usually just one like the snare...how could this be happening.....? Also am I correct in saying that the group channels db cannot be lowered below 0db? It can only boost the signal? Again because when I mute the group channel I'm still getting levels from the individual tracks. Is this working correctly or am I screwing something up?

Rusty K
 
I'm surprised no one has posted to my thread. Am I going to have to go over to the FASoft forum? So nobody has experienced this problem?

Rusty K
 
Are you sending anything from the original tracks into the aux channels? When you mute the group, you might still be hearing aux returns on those tracks. I've never experienced any bleed between groups. I'm still using 3.0 though.

Ben
 
bdemenil,

Yes I'm still on 3.0 too. I have effects on both the aux channels and to the snare etc....but how am I getting return from them into the vocal group channel?


Thanks,
Rusty K
 
You must log in or register to reply here.
Back
Top