attaching/mounting bass traps ?

  • Thread starter Thread starter yrdbrd
  • Start date Start date
yrdbrd

yrdbrd

New member
got some Roulex and started tryin to figure out where and how to install it all.
i've got the wall corners figured out and will have them done soon... have looked at a
lot of different studio pictures on here & on the net as well... & one thing i can't seem
to find much info on is how to mount the panels (2'x4') to the corner between the wall
& the ceiling. i've got a few ideas but was hoping to hear some of the ways people here
have installed theirs.


any input would be much appreciated TIA
 
I just went through this last night. Eye hooks in the middle of each side. Open hooks near the ceiling. Wire between them. It's a 2-person job.

*I also wound up putting one sheetrock screw below the panel for a rest to keep it from sliding down the wall.


lou
 
I did mine just like Lou, only I did all four corners with eye screws, then two eyes in the ceiling the two in the wall. Then I wired them up. They have been up over 2 years and I have had no problems.
 
Back
Top