Any Lathes out there ?

  • Thread starter Thread starter malcolm123
  • Start date Start date
malcolm123

malcolm123

New member
Need to cut a 12" with probably 2 songs per side.

This would be done with a original mixdown without any post processing. Or I could give a mastered version. This would be Hip Hop so if you have one, I would like the low end correct


Thanks

Malcolm
 
Son of Mixerman said:
Malcom123,

Contact Paul Gold at http://www.vinylmastering.net/

Lathes cost upwards of $50,000 so your not going to find alot of DIY vinyl ME's around here.


SoMm
Click to expand...

Ok gotcha

Thanks, I knew one of you guys would point me somehwere.

I hope it's cheeper than what we paid back in 98. LOL

that whole project was a learning experience and cost a bundle.

We were very green and gun-ho back then !!

Malcolm
 
I have a contact here in california that owns one..........if you're interested you can email me. There are only a small handful of people that own these so good luck!
 
You must log in or register to reply here.
Back
Top