G
Gitaroomaan
New member
Hey Guys,
I've been doing some recording on my ADAT-XT (haven't recorded with it before) and I have noticed somthing kinda strange. Whenever I record on track 1, the signal also shows up in track 5, with track 2 it's track 6, and so on up to track 4/8. Now, this doesn't matter to me, the problem is that when I try to record to track 5-8, it won't read anything, it's as if there is no input to those tracks. It's definetly not my mixing board, as I've tried different output methods and different cables, and it does the same thing. I'm thinking that somthing must be enabled on the ADAt itself, but I can't figure it out. Thanks for any help.
EDIT: Reading the manual proved that I am in fact an idiot, as the ADAT was on 4-Bus Mode as opposed to 8.
I've been doing some recording on my ADAT-XT (haven't recorded with it before) and I have noticed somthing kinda strange. Whenever I record on track 1, the signal also shows up in track 5, with track 2 it's track 6, and so on up to track 4/8. Now, this doesn't matter to me, the problem is that when I try to record to track 5-8, it won't read anything, it's as if there is no input to those tracks. It's definetly not my mixing board, as I've tried different output methods and different cables, and it does the same thing. I'm thinking that somthing must be enabled on the ADAt itself, but I can't figure it out. Thanks for any help.
EDIT: Reading the manual proved that I am in fact an idiot, as the ADAT was on 4-Bus Mode as opposed to 8.