44k to 96

  • Thread starter Thread starter Idgeit
  • Start date Start date
Idgeit

Idgeit

New member
Hey all,

I got a M-Audio 1010LT. And im trying to figure how can i change it from 44.1 to 96k in Sonar 4?. When i change it in the M-audio controls, It locks up the cards, and then it dosent work in sonar.

Any ideas?

Thanks

- Idgeit
 
I've got a 2496 so I may be wasting your time but...

To change sampling rates on my card you have to close all audio applications like Sonor and any media players that might be playing. Only then will the M-audio Control panel accept and maintain any changes. When you open Sonor again it should give you a sample rate change message.
 
Also, make sure you don't have the "Rate Locked" box checked in the Delta1010 control panel either. Afterwards, you may have to remove the aud.ini file and let the SONAR reprofile it.

Is the Delta control panel running when you have sonar up?
 
What punkin said...

1.un-checked "Rate locked" on Hardware settings tab (Delta control panel). Close it.

2. Open Sonar, click on Options --> Audio... set Sampling Rate to 48000. Click OK.

3. Restart Sonar...

That's it...

;)
Jaymz
 
Cool :)

Hey, did you figure out the Delta Control Panel routing problem in WinXP (monitoring)? If you still have any difficulty, just tell me, I'll get some snapshot of my Delta CP setting...

;)
Jaymz
 
You must log in or register to reply here.
Back
Top