1010LT outputs

  • Thread starter Thread starter Kevin Deschwazi
  • Start date Start date
Kevin Deschwazi

Kevin Deschwazi

Well-known member
I use Cubse SE and a 1010LT. I'd like to send one master out to a mixer (for headphone outs, monitoring etc.) and another to my power amp but I'm unsure how to do it. Currently I'm going to the amp via the mixer which I'd rather not do.

I've looked at the manual for both the card and Cubase but it doesn't seem at all clear.
 
Kevin DeSchwazi said:
I use Cubse SE and a 1010LT. I'd like to send one master out to a mixer (for headphone outs, monitoring etc.) and another to my power amp but I'm unsure how to do it. Currently I'm going to the amp via the mixer which I'd rather not do.

I've looked at the manual for both the card and Cubase but it doesn't seem at all clear.
Click to expand...

I dont understand what is the power amp for?
 
Monitors

The monitoring I referred to via the mixer was monitoring through headphones while tracking.
 
Kevin DeSchwazi said:
Monitors

The monitoring I referred to via the mixer was monitoring through headphones while tracking.
Click to expand...

Ok, I have two set-ups Pro Tools 002 and I also have Cubase SE and a Audiophile 24/96 the main outs are sent to the input of two channel strips in my mixer the I send my control room outs from the mixer to my amp for my monitors
 
Carter said:
Ok, I have two set-ups Pro Tools 002 and I also have Cubase SE and a Audiophile 24/96 the main outs are sent to the input of two channel strips in my mixer the I send my control room outs from the mixer to my amp for my monitors
Click to expand...

Thanks Carter,

That's similar to what I do but I want to bypass the mixer completely for monitoring. I think it's unnecessary and I'm sure there's a way of doing it with my card.

I've got all those lovely outputs on the 1010LT and I'm only using two of them.
 
Kevin DeSchwazi said:
Thanks Carter,

That's similar to what I do but I want to bypass the mixer completely for monitoring. I think it's unnecessary and I'm sure there's a way of doing it with my card.

I've got all those lovely outputs on the 1010LT and I'm only using two of them.
Click to expand...

WOW, Im sure that you can bypass the mixer, send the direct outs to your amp and control it thru the M-Audio control panel, that should work ;)
 
Last edited:
Add another Stereo output bus (VST Connections) assigned to whatever output pair you want to use.
Then just use the sends on each track to create monitor mixes.
Use the master output bus for your amp and monitors and use the other output bus and the track sends to create your tracking monitor mixes via mixer, headphones ...etc.

I'm not familiar with the Delta control panel, so I don't know what to say there. :confused:

HTH
 
You must log in or register to reply here.
Back
Top