Recent content by Theeoddname

Don’t know for sure but I’ve got a TLM-103 and two Deity S-mic 2’s. Had troubles with all three mics. I never tried the instrument input so couldn’t say with that. That said, I seriously doubt it’s your TLM-102 as that mic should have plenty of signal (assuming you’re turning on phantom power)...

I had a defective unit. Once I got it replaced everything worked as expected.

Never mind. Looks like i overlooked something - this also sends M1-M2 as preEQ .... I think I can work around this though if I’m dealing with only two input sources through the pan option.

Could you look at this diagram and confirm me thinking - this mixer has the 1-2 mic output to usb as Post Fader.... please? https://www.allen-heath.com/media/ZEDi-10FX-Technical-Datasheet.pdf

May be useful for you to know what I have already: 1) macOS 2) Logic Pro X, Final Cut Pro X, OBS 3) Neuman TLM 103, Deity S-Mic 2 4) Focusrite Scarlett 2i4 gen 3 5) Focusrite Clarett 4PRE-USB 6) Canon G7x-iii and Sony RX100-iii and should I go music production - which I do dable with music on...

A bit of an update: I decided to get Loopback for my macOS. This is allowing me to create digital audio devices which is helpful because now I can feed OBS individual mic's as an audio source from a single audio interface as opposed to having all mics from the hardware source be mixed into a...

Headphones worked fine but the one-ear was an issue.

Update Usecase & Motivations A bit of an update: I decided to get Loopback for my macOS. This is allowing me to create digital audio devices which is helpful because now I can feed OBS individual mic's as an audio source from a single audio interface as opposed to having all mics from the...

Great stuff here. Thank you! ---------- Update ---------- Please explain to me why headphones cannot be used to monitor an AUX out? I just did this last night on an ol'cheap'o I snagged up and it worked fine: both on the AUX and the Group outs as well as the headphone outs. That said, it...

Thank you for the response. This is most helpful in my education journey here. I certain have a lot to learn -- but it's been enjoyable thus far. What I got from your post is -- AUX and Monitor sends are different signal levels and thus cannot be treated the same without accounting for the...

Thank you folks. The Soundcraft GB2R hasn't been on my radar so this gives me some avenues to go after! As for the software solution -- really trying to avoid that route specifically because I'm wanting to physically turn dials and such...bit old school this way. However, if there's software...

I guess another way to ask this is: Is there a multitrack USB audio interface mixing console which will allow the USB signal to be passed to the computer post fader. So far, all I'm seeing is that the Master Mix is passed post-fader but each individual input is passed pre-fader.

I want to be able to send to my DAW, OBS, Voice Recorder or what’re ever on my computer AFTER the mixer has its complete adjustments to the input channel. So I want to be able to adjust the EQ, FX, etc and then send to the DAW the channel’s post fader signal via USB. I also want this to...

I want to be able to send to my DAW, OBS, Voice Recorder or what’re ever on my computer AFTER the mixer has its complete adjustments to the input channel. So I want to be able to adjust the EQ, FX, etc and then send to the DAW the channel’s post fader signal via USB. I also want this to...

So there's a few ways this can be done and works with pretty much any phone like system. 1) Take the headphone out from the computer (or your phone) and send that to the mic input line on the mixer (or interface). This allows you to hear the caller. 2) Take a headphone out from the mixer (or...