Recent content by ron-e-g

Watch that jump in page 15 to 19. I think some important information on normalizing the stereo returns on the PB 664's if you have them. as I recall.

I did. I ended-up using the Tascam LA 40 & LA 80 to connect some outboard gear. Worked flawlessly. What a awesome board these are.

Sorry SunkenCity I no longer own the M600.

Sorry, Long since gone.

sweetbeats, wkrbee jpmorris, and altrustica. Just wanted to say thank you to you guys for all your help, and responces on this post. Ron

Couple of things. Are these the same? What is this? Could I have inadvertently changed this? What would it matter? I checked this. The arrows show power travel from plug on rear of machine. It looks to be the first point of power to the Unit.

I've determined this so far. This machine powers on a few different ways. 1. Semi normal as far as the control board lights are concerned. They all flash the red color (exception, vari speed amber) as shown in the picture I provided. then settle down to the Same..as shown in the video I...

I emailed them Again today. Got a response back. First..your right It's Montebello, not Montecito. I always thought they were there. $90 evaluation. fee. applies to repair if done. At $90 per Hr. Plus at least twelve hours driving time. Could get real costly. Especially, since I don't have a...

Actually 1h 45 min. I contacted them 6-7 weeks ago, when I thought I only had an amp card issue. I never heard back, so I assumed they no longer worked on these.

Cory, First of all no worries! I can take it.:D I 100% agree with your every word. This is beyond my capabilities. I'm a carpenter/woodworker. As you can tell by that thumb in the video!:facepalm: I live in Arroyo Grande CA.

Thank You sweetbeats. https://vimeo.com/190018771 New observation; If I wait some time, say a couple of minutes after power off. The machine will do what you see in the video. However, if I power on right away it will not Flash all the red leds. Too, I tried leaving the power on about 20...

Guess I need a lesson in video upload. All I get at Vimeo is a http. Not a URL! I've posted vid's before, but can't remember now how. Sorry..Can't seem to delete a post on this site either.

How the heck do I delete a post!?

wkrbee, Had to re- set my email don't know why. So your PM did not reach me. Update; Got the unit back yesterday. From the other, local electronics repair guy. He said he checked the power supply. "It's all good" he said. I'm a little unsure, as to his ability, on this particular machine. As I...

Yep..Among the other things. I can't believe anything I have done could cause this. All I have done is disconnect, and connect the DBX card connectors, remove, and reinstall the Amp cards and spray around some DeoxIT! Oh and disconnect, and re connect the control panel connectors. I did BTW...