Recent content by ellery

Or you could just set the M-Box as your default sound output... Are you on a PC or a Mac? If i remember correctly on a PC you can go to the "sound" control panel and select the M-box as your default output....

I use a mg16/4 for radio remote's. I have had good luck with it. The yamaha's are good workhorses.

I use Lacie firewire 400 drives to track and Mix from. No performance issues so far. (recorded 24 tracks at 96k). A small tech note. Just because a drive has an interface speed of 100MB/s does not mean it can move data that fast. Most of the drives i have tested range from 34MB/s to 60MB/s i...

Check out this page on signal flow. http://emusician.com/consoles/emusic_mixed_signals/ Here is the key. The fader/slider has nothing to do with the Preamp. The trim Pot does. (Very top of the board you will see a knob labled trim) There is a white box about one third down from Top dead center...

It sounds like a splice, Loop and drop job to me. with reverb and flanger. Take the vocal track and chop it up. Loop Parts and drop others

Check the source switch. also go into I/O setup and make sure the input levels are set

another note. THe converters where beri not digimaxs. I tracked this right before i got the digimax

nope the violin is a real one. I agree with everyone here. The drums are going to be retracked and i'm thinking about retracking the agtr too. Ellery

the drums where sub mixed... so ya they are pritty bad.

This is my first mix. I recorded this on a digi 1 and digimax converters. This was done live at a show. with a local band. Let me know what you think. Thanks for your time http://video.paulding.com/When%20you%20say%20nothing%20at%20all%2006-09%20mix.mp3 Ellery

This is my first mix. I recorded this on a digi 1 and digimax converters. This was done live at a show. with a local band. Let me know what you think. Thanks for your time http://video.paulding.com/When%20you%20say%20nothing%20at%20all%2006-09%20mix.mp3 Ellery

It's pricey but take a look at media 100 great system i worked with it for about 2 years and loved it .

Apogee ad-8000 digi 888/24 digi 192 I/O the Apogee is the best out of the stack. i love the range they give me and how the clocks are so stable.

Jim DeMain at Yes Master in Nashville. if you need his contact info let me know. I have worked with him on two projects he has a gift

Check your sample rate setting. i have seen that cause issues with speed before.example your signal is comming in 44.1 but your masterlink is set to burn at 48k