Recent content by Dahoxic

(Here’s some of my background for context) I had never recorded in a professional studio until 2021. My band at the time cut a record to 2inch tape and the engineer made it seem so effortless Leaving that experience i was really inspired so I bought this console for $100 about two and a half...

thanks again for the information! SO I'm having trouble sourcing all nichicon brand capacitors and their associated values for the 10 smaller capacitors in the PSU. Is it a problem to mix capacitor brands in this case? Also can I use a bi polar cap in any instance here? You guys are a plethora...

Squealing sounds more like it. But at those bass frequencies so like flubbing might be a better word lol. Becomes a more straight up tone when the frequency is shifted higher. But is correlated to boosting the gain. Which caps are limited to the eq section exclusively? I don’t mind recapping...

So I did the first 6 big caps and was successful. Accidentally tore off a solder eyelet pad and used a component lead into a teeny tiny circle with some flux and it was solid! Any dice on a replacement EQ pot? Manual says 10k (B) + 100k (E) This bass eq gain knob is causing some weird...

Thanks guys

Hey guys, returning to this thread to say I finally cracked open the PSU and am going to start with the 6 big caps to begin with. Just ordered them. Also I wanted to note the ground strap lug and the associated nut was loose in the PSU housing!

So, a couple of questions I've been asking myself these past few weeks from my last post here. Regarding the general noise floor of the console, I've decided I should recap my power supply to see what my baseline for other channel repairs might be. I've never recapped any old electronics, but...

I ended up taking the apogee out the rack and removed the odd numbered jumper pins (1-16) on the DAC output card for “pin 2 hot unbalanced operation” I also added an air gap between the console PSU and apogee. This seemed to fix my input and output issues.

Yup you’re correct. It’s interesting to me that an interface from 20ish years ago, I couldn’t get all the required information even from the company directly. If it weren’t for that forum I never would’ve figured out this problem. Thanks for the help on this guys. All the information I can get...

Small update because I’ve been so busy. I removed the apogee from the rack and took out the accessory DAC output card. I removed the odd numbered shorting pins for “pin 2 hot unbalanced output” and reinstalled the card. (this solution I found in a forum on gearslutz) also this information I...

So from top to bottom. M520 direct outs 1-16 normalled to Msr 16 inputs Msr 16 tape outs 1-16 normalled to M520 tape in 1-16 Non normalled 4 track output and input (red) (5-6 N/A) (7-8 Rca Stereo master A normalled to monitor amp inputs) (9-16 Rca 1-8 m520 program groups normalled to...

I’m just confused as to how the direct out is bleeding back a distorted harmonic into the fader when turned up yet no bus is assigned. But only when making a patch from the direct out

Thanks for taking the time to inform me about this stuff. Hm. So what do you suggest my options are, if you’re saying this extra cable is redundant?

I have my m520 direct outs on an unbalanced patch bay normalled to the line ins on my MSR 16. The input of my apogee AD8k is on a balanced patch bay with TRS (bay) to XLR. The output of the apogee is fully normalled to line inputs 12-20.

Interesting I have not tried this! But get this - my power supply has a 3 prong cable! So somebody must have modded it at some point? I have a morley hum eliminator that I use when recording stereo amps that I could use to try to incorporate your proposed solution but I know disconnecting the...