Recent content by champagne_charl

Thank you very much. Far better than i can sketch, Sorry for the late reply. Finally received some xlr plugs and a digi 002 I have wired as follow tip > Hot > XLR 2 Sleeve >Cold >XLR 1 Not conneted > Shield > XLR 3 No hum. WOuld a capacitor/resistor improve the above? Should it go...

Thank you for such a comprehensive reply.. again.. I'll reply fully soon.. For now.. The mic in the 630: http://site.jjstech.com/pdf/Casella-pdf/CEL-251-Measurement-Microphone-Capsule_Datasheet.pdf Could one problem with the audio capture of the spl during calibration and using attenuation...

For a better indication of what i wish to achieve. I live in a leasehold property where the floorboards of the flat above along with joists are in disrepair. They creak like hell. and also bang dependent upon where. EH have no backbone and believe it or not don't understand SPL or frequency...

Checked cable impedance which is 110ohms.. So purchase some resistors to match..

Actually no its not my normal manner.. not really. not unless i feel i'm addressed in that way or similar. That said. You are right. Point taken and understood. Thanks again for your comments.. cel 440 : manualsdir.com/manuals/get?doc=750022&h=0240c1547c0165d6793b13a52f6319f17cc4703d cel...

Thank you Dave for your comments. Thank you for pointing out the lack of clarity in the post. I shall correct the ambiguities and confusing typos shortly. Spelling has always been a major weak point. With regards gto comments. I do apreciate his efforts. Please excuse my bluntness with...

Thanks for your efforts although not terribly helpful. Issue found. The xlr adapter I purchased maps tip to pin 1 instead of pin 2 then shorts it to pin 3. Xlr connectors arriving tomorrow should fix this.

Hi all. Am New to audio currently working on a noise monitoring project.

Hi, Ok so my first post.. I’m hoping for some advice if poss. I am trying to monitor noise with sound level meters and want to capture the audio to file. What I'm using is an mbox2. I did have some brief success capturing quality audio then something went pear shaped. I tried another meter...