DDev
New member
Since this is the "Mixing" forum, I'll try this question here.
I just recently purchased my first outboard fx processor and a compressor, and am trying to figure out how to route them with my mixer's I/O.
My mixer is an older Yamaha 24 channel board (MX400) that has 5 Aux sends but no returns. There are individual channel inserts, stereo bus inserts, group inserts (4 sub groups), and group inputs. I'm currently using channels 1-16 for audio input from my ADATs. My fx processor can be split to use the separate inputs as individual processors, and this is how I intend to use it for now.
I think I've seen somewhere that people use open mixer channels for this, but for the life of me I can't find any descriptive diagrams that show how to do this properly.
Any help would be appreciated.
Darryl.....
I just recently purchased my first outboard fx processor and a compressor, and am trying to figure out how to route them with my mixer's I/O.
My mixer is an older Yamaha 24 channel board (MX400) that has 5 Aux sends but no returns. There are individual channel inserts, stereo bus inserts, group inserts (4 sub groups), and group inputs. I'm currently using channels 1-16 for audio input from my ADATs. My fx processor can be split to use the separate inputs as individual processors, and this is how I intend to use it for now.
I think I've seen somewhere that people use open mixer channels for this, but for the life of me I can't find any descriptive diagrams that show how to do this properly.
Any help would be appreciated.
Darryl.....