Hey guys.
So up until this point, I've been using the Steinberg UR44, "6x4 USB 2.0 audio interface with 4x D-PREs, 24-bit/192 kHz support & MIDI I/O" to connect my equipment. Full specs, Specs & Downloads.
However, I just purchased an Allen & Heath ZED-12FX (ZED-12FX - Allen & Heath) because I have a few new pieces of equipment to plug in, and was wondering if there would be any reason for holding on to the UR44?
At this point, is the mixing board fully capable of taking over the duties of the UR44 audio interface, or would there be any reasons to use them together in some way?
Thanks for any insight.
ARNK
So up until this point, I've been using the Steinberg UR44, "6x4 USB 2.0 audio interface with 4x D-PREs, 24-bit/192 kHz support & MIDI I/O" to connect my equipment. Full specs, Specs & Downloads.
However, I just purchased an Allen & Heath ZED-12FX (ZED-12FX - Allen & Heath) because I have a few new pieces of equipment to plug in, and was wondering if there would be any reason for holding on to the UR44?
At this point, is the mixing board fully capable of taking over the duties of the UR44 audio interface, or would there be any reasons to use them together in some way?
Thanks for any insight.
ARNK