Search results

Wanting WORKING reasonable priced Teac RC-100 remote control for reel to reel

I need some help in locating 9 , 14 pin female card holders that go in the bottom of the deck in the amplifier section. Looking for possible sources for GOOD new or used 14 pin female card recepticals. Teac part# 50438380 . There is no locator in the receptical nor a locator notch on the boards...

I am in need of finding a source for the 9-14 pin card recepticals in the bottom of the deck in the amplifier section. TEAC part#50438380. Theese recepticals do not have a locator key or notch out on board. I would greatly appreciate some help in finding some GOOD new or used. I would prefer a...

I have a PRIMO Teac A-7300-2T. Out of the blue the brake solenoids quit working. They are mechanically free and ohm out to the same value. I checked everything listed in the service manual ( which was very little ) and everything questioned checks out OK. I am at a loss on where to go next and...

I could use some help on this unit. Out of the blue the brakes quit working. Mechanically they are free and ohm out the same value. I've tried all the trouble shooting out of the service manual ( which was very little ). I don't know if this is a clue or not , but when you power the deck up the...

TEAC A-7300-2 Need some help troubleshooting I have a TEAC A-7300-2T.I believe it to be engineered by TASCAM but TEAC labeled. It is a studio PRO unit with built in mixer and 4 XLR inputs. It is all IC controlled.Out of the blue both brake solenoids quit working. They are mechanically free and...

I have a issue with this deck and could use some suggestions. Out of the blue both brake solenoids stopped functioning. Mechanically are free. Both solenoids ohm out at same value. I have checked everything suggested in service manual ( which was very limited ). This deck literally is PRIMO! I...

Recently purchased a very nice Teac X-1000R. What would be a good quality tape to use on this machine without over extending its capabilities. secondly I hear a lot of reference to decks being aligned for certain tapes. How is that accomplished. This is my 1st R2R! Thanks.:confused: