Tascam 464-Recording on Track 4

1

1981Recording

New member
Hi,

I'm trying to record on all four tracks at once and everything works except track 4. I get a signal, I can hear it in the monitor, but it's just not recording and I've probably tried every position and setting. It doesn't matter whether it's a guitar straight in with direct selected or a mic via XLR. The other three channels record perfectly. I've also read up on the 424 manual and the 488 manual, but still can't get it to record. Any help in plainly explaining the exact settings, how to pan it, what to turn off, what to turn on, etc would be a great help. I'm a novice at this so not too savvy with the terminology and stuff.

Thanks!
 
check the back of the unit, these had an option to run a midi code stpripe on track 4, thus omitting track 4 from use.
so on the back of the unit there is a switch i believe, make sure its not switched to midi code.
(its a little black slider switch)

that should do it
 
Agreed

The switch is dbx on/off/Sync.

The Sync setting will defeat dbx, and although I've not tried it, in a lot of cases it will also remove track 4 from the audio path (which would only make sense).

Put the dbx switch to "On" for recording and playback.

:spank::eek:;)
 
You must log in or register to reply here.
Back
Top