Nate74
HR4FREBR
I've replaced the capstan drive belt and thought I was good to go on my Tascam 38, but I've discovered now that when the unit is sitting upright, the capstan wheel (not the motor but the heavy flywheel side) slides forward towards the front of the unit just enough to rub against the plate it's mounted to. There doesn't seem to be any way to adjust this and when it's on it's back, there seems to be a 1/16" or so gap so no rubbing and it runs fine.
Any help at all would be MOST appreciated. I can't really run it on it's back...
Thanks in advance.
Any help at all would be MOST appreciated. I can't really run it on it's back...
Thanks in advance.