Running unbalanced outs into guitar amp.

[TripleJ]

Hey,

I'm experimenting with re-amping and such and find that if I run a cable out from my digi001 and into my guitar amp that I get a lot of hum/noise.

I take it this is because the output is a -10 low impedance and the guitar amp input is a high impedance, right?

How do I correct this?

Is it possible to use my crappy Behringer DI box to match these impedances? If so how?

Thanks guys!

 

[boingoman]

Make sure both pieces are plugged into the same circuit first, it sounds like a ground loop.

 

[TripleJ]

I'm quite sure they both are but I'll double check. My 'studio' is in a separate shed behind my house so I doubt they ran two circuits there.