AllenM
Member
Hello,
I've had this issue for awhile but certain channels on my Ramsa board pass clean signal, then get faint and distorted. To resolve this I bump up the gain (max) and it goes back to a clean signal for a brief period, then back to low output and distortion.
Any ideas as to what is causing this? I do believe it is the channel strip as it does it on tape returns and mic preamp. The Xlr ins are connected to a channel snake. I haven't bypassed the snake but I dont think the snake is whats causing the problem.
I've had this issue for awhile but certain channels on my Ramsa board pass clean signal, then get faint and distorted. To resolve this I bump up the gain (max) and it goes back to a clean signal for a brief period, then back to low output and distortion.
Any ideas as to what is causing this? I do believe it is the channel strip as it does it on tape returns and mic preamp. The Xlr ins are connected to a channel snake. I haven't bypassed the snake but I dont think the snake is whats causing the problem.